The 122 AMA was introduced to complete the full recreation of a classic tonewheel organ sound system.
122 Absolute Modeling Amplifier [...]

Our double mount for our “Hot Rod” driver, suitible for higher then stock power or for additional SPL.
Dual Hotrod Installation [...]

Replacement woofer for Leslie™ models 22H, 47W, 142, 122, 222, 145, 147, 247, 251, 351 speaker cabinets.
Even vintage woofers had [...]

We offer both the “HotRod” (Titanium) and “OEM” (Phenolic) drivers. Both are “Screw on” drivers and use our adapter to [...]

Universal Solid State Relay for 122 and 147 series amplifiers.
Universal Solid State Relay Instructions

Provides high voltage needed by early Hammond™ pre-amplifiers, allowing the use of other audio systems without using a 22H/122 type [...]

The Bassmon is designed to provide full 16′ tones and “pluck” percussion on the lower keyboard of a Hammond™ organ.
Bassmon [...]

The Caribbean Motor Controller is used in several kits we sell. In all cases it permits the use of “Fast” [...]

Our reproduction hammer tips, used to replace the original hammer tips onHohner Clavinets.
Clavinet Hammer Tip Kit Instructions

Speakeasy manufacture’s a variety of connector kits for connect different organs to different Leslies™. These are the “Standard Kits”, recreations [...]

Recreation of the Dyno-my-Piano Pro EQ preamp. This page covers the Dyno Stagebox, Dyno Vibrato Pedal, and Suitcase Dyno Preamp. [...]

A “plug and play” hookup kit allowing the use of a Leslie™ 122 (122 version) or Leslie™ 147 (147 version) [...]

Converts any tonewheel Hammond™ model B, C, D, E, G, BV, CV, RT, B2, C2, RT2, B3, C3, and RT3 [...]

Transposes tonewheel Hammond™ model B, C, D, E, G, BV, CV, RT, B2, C2, RT2, B3, C3, and RT3 [...]

Headphone adapter kit for Hammond™ tonewheel consoles with “G-G” outputs. (A, B, C, D, E, G, BC, BV, CV, RT, [...]

MIDI equipped vintage Hammond™ pedal clavier (pedalboard) for use as a controller for any MIDI equipped keyboard or sound module.
MIDI [...]

Pedal booster which enhances the depth of the 16′ drawbar on a vintage B3/C3/A100 and earlier consoles.
MoBass Installation Instructions

The MOS-1618 is a connector kit designed to connect a Leslie™ Model 16, Leslie™ Model 18, or Fender Vibratone to [...]

Replacement “Rubber” tips for the hammers of Rhodes™ Stage and Suitcase models. Tips are graded hardness like the originals, including [...]

Kit for adding “lift” to the key pedistals, produces better dynamics and quicker action.
Rhodes Lift Kit Directions

Replacement damper springs for vintage Rhodes™ Pianos.
Replacement Rhodes™ Damper Instuctions

Exact copies of the original Tines, used to replace broken Tines on vintage Rhodes™ Pianos.
Rhodes™ Tine Installation Directions

Slide pots for replacing the controls on a Stage 54 or Janus Suitcase model.
(On Rhodes™ Janus models use the guide [...]

Bright kit adds tweeters to the lower cabinet of a Suitcase model Rhodes™ Piano.
Suitcase Bright Kit Installtion Instructions
Scotchlok™ Instruction Sheet [...]

Also know as the “Tap Off Box” and “Line Out Box”, it is used on consoles and spinets to provide [...]

Adds input and output jacks for adding effects to B3, C3, RT3, B2, C2, RT2, A100, and D100 model Hammond™ [...]

Adds Bass and Treble controls to B2, C2, RT2, B3, C3, RT3, A100, and D100 model Hammond™ Organs.
Tube Tone Booster [...]

Available in both a Pedal and a Rackmount format these preamps provide ample drive for Leslie cabinets and great vacuum [...]

Replacement reed for Wurlitzer 200 series pianos (200, 200A, 206, 206A, etc.)
Wulitzer Reed Directions

Replacement electronics for Wurlitzer 200 series pianos (200, 200A, 206, 206A, etc.)

Wurlitzer 245 Documentation
Wurlitzer 245 VER 2 Documentation